Care And Cleaning; Troubleshooting - ETI 53182201 Manual De Uso Y Cuidado

Mount to 4 in. Housing (continued)
3
Connecting the cables
□ Plug the cable connector on the socket adapter (E)
into the connector on the LED light module (D) .
E

Care and Cleaning

CAUTION: Before attempting to clean fi xture, disconnect the power to the fi xture by turning the breaker off or removing the fuse from the
fuse box .
□ Clean the fi xture with a soft, dry cloth .
□ Do not use cleaners with chemicals, solvents, or harsh abrasives .

Troubleshooting

Before doing any work on the fi xture, disconnect power to the light fi xture .
WARNING:
Minor problems often can be fi xed without the help of an electrician .
Problem
The fi xture will not light .
The fuse blows or the circuit breaker
trips when the light is turned on .
4
D
D
Possible Cause
The power is off .
The circuit breaker is off .
There is a bad connection .
There is a defective switch .
The LED tubes are installed incorrectly .
The wires are crossed or the power
wire is grounding out .
7
Pushing the LED light module into
the recessed can
□ Carefully push the LED light module (D) into the
recessed can housing until the trim is fl ush with the
ceiling surface .
Ensure the power supply is on .
Ensure the circuit breaker is in the on position .
Check to ensure proper wire connections are made .
Contact a qualifi ed electrician .
Contact a qualifi ed electrician .
Install LED tubes with the end labeled "power this
end" to the wired sockets .
Check the wire connections .
Contact a qualifi ed electrician or call customer
service 1-855-384-7754 .
Solution