Operation Guide; Replacement Of Batteries In Remote Controller - d2itsu APD-12CK Manual De Usuario

Operation guide

1. After putting through the power, press "
turn on the air conditioner.
2. Press "
MODE
HEAT.
3. Press "+" or "-" button to set your required temperature. (Temperature can't be
adjusted under auto mode).
4. Press "
FAN
high speed.

Replacement of batteries in remote controller

1. Press the back side of remote controller marked
the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
NOTICE
● During operation, point the remote control signal sender at the receiving
window on the unit.
● The distance between signal sender and receiving window should be no
more than 8m, and there should be no obstacles between them.
or wireless telephone; remote controller should be close to the unit during
operation.
● Replace new batteries of the same model when replacement is required.
● When you don't use remote controller for a long time, please take out the
batteries.
● If the display on remote controller is fuzzy or there's no display, please
replace batteries.
" button to select your required mode: AUTO, COOL, DRY, FAN,
" button to set your required fan speed: auto, low, medium and
" button on remote controller to
ON/OFF
13
signal sender battery
reinstall
remove
Cover of battery box