HoMedics Comfort Pro Professional Manual De Instrucciones E Información De Garantía página 3

Adjusting the Leg Height
• Start with the table fully opened – laying on it's side or upside down.
• Unscrew the locking knobs on each leg (Figure 5), remove the leg, place
the leg at the position you have chosen, and replace the locking knobs.
Holes are numbered for easy match up. Do not over-tighten knobs.
(Figure 6) Snug will do fine.
• Changes in humidity and temperature affect wood, it is a good idea to
double check the tightness of the knobs occasionally.
Caution: Always adjust all 4 legs to the same height.
Fig. 5
4
Instructions for
Comfort Pro Massage Table Take-Down
• Slide wooden face cradle base out of the end of the table.
• Remove face cradle pillow from wooden face cradle base by separating
the Velcro pieces from each other.
• Attach the wooden face cradle base to the bottom of the table by
matching up the Velcro on the base to the Velcro underneath the table.
• Turn table upside down or on it's side.
• Unlock table legs by pressing in on each leg at the joint. (Figure 7)
• Collapse all legs in. Place face cradle pillow behind legs for storage. Fold
the table in half.
• Latch the clasps that hold the table closed.
Fig. 6
Maintenance
• To wash use a light soapy water solution to clean all surfaces.
• Avoid harsh chemicals or solvent based cleaning products.
• Do NOT use any alcohol, alcohol based, or petroleum based cleaners.
Doing so may damage the upholstery material on your table.
• If any of the cables on the bottom of the table break, stop using the table
immediately.
Fig. 7
5