Publicidad
SLIDING DOOR HARDWARE - Pocket Door
5
mOuNt DOOR HARDWARE
• Place quick release top mount plates on top of each
door at the distance shown from the outside edge.
• Using brackets as a template, drill 3/32" diameter
holes and secure with (#8 x 1") screws. (j)
• Drill 3/32" diameter hole and secure door
with (#8 x 3/4") screw. (m)
5-1/2"
(14 cm)
Front
Avant
Delantera
7
FINISH jAmBS & tRIm
• (A) Install vertical finish split jambs, butting them all the way up
against exposed wood in nailing strips to header assembly.*
Leave 1/8" minimum distance on both sides of door. Check
clearance with door open and closed.
Note: The door guide may be installed between the split stud
and finish split jamb.
• (B) Install finish split header to the exposed nailer on
either side of the track, leaving 3/16" clearance on
both sides.
• To allow for future door adjustment or removal, at
least one finished split header should be attached
with screws only: The one on your right hand
overhead as you face the door in the pocket is
recommended.
• Install finish trim casing. Fasten finish header trim
to EItHER header OR wall, NOt BOtH, so header
can be removed later without damage.
• Attach door guide to finish split jamb (if
installing on the exterior) using (#8 x 5/8")
screw, (L) and adjust to within 1/16" of door
on either side.
*Note: Standard doorway jamb can be ripped to suit.
1-1/2"
(3,8 cm)
Rear
Arriére
Parte trasera
A
6
HANG DOOR
• Install door, mounting rear edge first, then front edge.
• Open quick release latchs on brackets.
• Slide door onto carrier screws and close latch.
Rear
Arriére
Parte trasera
Center
Centre
Centro
1/8" min
(0,3 cm min)
Finish split header
(Fasten with screws)
Linteau Fendu de Finition
(Fixer avec vis)
Cabecera hendida de
acabado (fijar con tornillos)
#310309_C (1013)
Assembly
Instructions
1/8" min
(0,3 cm min)
B
Finish trim
Habillage
de finition
Embellecedor
de acabado
Publicidad
