Wiring Diagram (Tunnel 70); Disassembling, Demolition And Elimination Of Residuals; Chapter 7. Guarantee; Certificate Of Guarantee - Minipack-Torre Tunnel 50 Digit Instrucciones Para La Instalación, Uso Y Mantenimento

Chapter 6. Ordinary maintenance

6.5.2. Wiring diagram (Tunnel 70)

(figure 6.5.2. page 56/57).
BT1 Thermocouple
ER1 Resistor 2
ER2 Resistor 2
ER3 Resistor 2
ER4 Resistor 1
ER5 Resistor 1
ER6 Resistor 1
F0 Auxiliary fuse
F1 Transformer inlet fuses
F2 Inverter fuses
F3 Fan motor fuses
F4 Resistors fuses 2
F5 Resistors fuses 1
FU2 Board fuse

6.6. Disassembling, demolition and elimination of residuals

ATTENTION!
All operations about disassembling and demolition must be done by qualified personnel with mechanical
and electrical expertise required to work in security conditions.
Proceed as follows:
1. disconnect machine from power mains
2. disassemble components
All wastes must be treated, eliminated or recycled according to their classification and to the procedures in
force established by the laws in force in the country the equipment has been installed.

Chapter 7. Guarantee

7.1. Certificate of guarantee

The guarantee runs for 12 months after the installation date under the conditions set forth on the instruction manual. Fill
in the card with all data requested,tear out along the perforations and send in

7.2. Guarantee conditions

The guarantee runs for 12 months and goes into force on the installation date of the machine. The guarantee covers
free replacement or repair of any parts due to defects arising from faulty material. The repairs or replacement are
usually carried out at the manufactures, with transport or workmanship at buyer's charge. If the repair or replacement is
carried out at the buyer's place, he shall bear the travelling, transfer and workmanship charges. Work under guarantee
can be carried out exclusively by the manufacturer or by the authorised dealer. In order to be entitled to repairs under
the guarantee, the faulty part must be sent for repair or replacement to the manufacturer or his authorised dealer. The
return of such repaired or replaced part will be considered to be the performance of the guarantee.
The guarantee is voided:
1. in case of failure to mail the CERTIFICATE OF GUARANTEE, duly filled in and signed, with in 20 days after the date
of purchase.
2. in case of inappropriate installation, power supply, misuse and mishandling by unauthorised persons.
3. in case of changes made to the machine without prior agreement in writing by the manufacturers.
4. if the machine is no longer the property of the first buyer.
The manufacturer decline any responsibility for damage to persons or things in case of inappropriate
installation or connection to the power mains or omission of connection to earth or in case of any mishandling
of the machine. The manufacturer undertake to carry out any variations and changes made necessary by
technical and operating requirements.
FM1 Fan motor guard 1
FM2 Fan motor guard 2
M1 Fan motor 1
M2 Fan motor 2
M3 Belt motor
Q1 Main switch
QM0 Inverter contactor
QM1 Fans motors contactor
QM2 Resistors contactor 2
QM3 Resistors contactor 1
S0 Emergency pushbutton
SK1 Control board
T1 Auxiliary transformer
TS1 Inverter
.
14