Publicidad
Idiomas disponibles
Idiomas disponibles
12. Tube shrinking continued...
The rings from the SRM wraps may be visible as the tubing is shrunk.
Post heat the connector area until the tube surface is smooth and the
underlying SRM wraps are no longer visible.
13. Position red insulating tube; shrink in place
Center the tube over the black stress control tube. Shrink in place
using the same method as in Step 12.
14. Apply red sealant
Remove backing from red sealant. Using light tension, wrap sealant
over the cable, butted against the tubes as shown. Build the sealant
to the level of the red insulating tube.
15. If using Drain Wire or UniShield cables
Remove backing and install the aluminum deflector around semi-con
as shown.
16. Center black/red triple layer tube; shrink in place
Center the tube over the splice. Begin shrinking at the center (1) of
the tube, working the torch around all sides of the tube. After the
center portion shrinks, work towards one end (2), then to the opposite
end (3).
Note: Do not point the flame at the cable semi-con.
Note: Pay particular attention to the hard to reach parts, especially
the back and underside of the tube. The tube should have a smooth
and even surface when finished.
Post heat the entire tube for 1 minute after fully shrunk.
Note: If External Grounding or Shield Interrupting
Refer to the Tyco Electronics HVS-EG, "Guide for External Grounding
and Shield Interrupting of Power Cable Splices" for modifications to
these instructions.
PII 53106
Revision AL
Red Insulating Tube
Tubo Rojo de Aislamiento
Red Sealant
Red Insulating Tube
Tubo Rojo de Aislamiento
Red Insulating Tube
Tubo Rojo de Aislamiento
2
Black/Red Triple Layer Tube
Tubo Nergro/Rojo de Triple Capa
Center tube
between jacket cutbacks
5
Visible wrap
lines
Shrink tube until smooth profile
Torch
Red Sealant
AluminumDeflector
Red Sealant
Torch
3
1
1
PCN 690615-000
Effective Date: June 17, 2010
116
118
117
270
607
Publicidad
