Charging The Battery, Leds; Charging The Battery; State Of Charge; Leds On The Battery - Stihl SHA 56 Manual De Instrucciones

6 Charging the Battery, LEDs

► If you cannot carry out these steps: Do not use the
vacuum shredder and contact your STIHL dealer for
assistance.
6 Charging the Battery, LEDs
6.1

Charging the Battery

The charging time depends on several factors, e.g.
temperature of the battery or the ambient temperature. The
actual charging time may differ from the specified charging
time. For specified charging times see
www.stihl.com/charging-times.
► Recharge the battery fully as described in the instruction
manual for the STIHL AL 101, 300, 500 chargers.
6.2

State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
► If the LED on the right flashes green: Charge the battery.
6.3

LEDs on the battery

The LEDs can indicate the state of charge of the battery or
any faults. The LEDs can be steady green, steady red or
flashing.
0458-828-9821-A
If the LEDs are steady or flashing green, this indicates the
state of charge of the battery.
► If the LEDs glow or flash red: Troubleshooting, @ 19.1.
There is a malfunction in the vacuum shredder or battery.

7 Assembling the Vacuum Shredder

7.1
2
80-100%
60-80%
► Pull the blower tube (3) out of the suction tube (2).
40-60%
20-40%
► Pull the nozzle (4) out of the nozzle (1).
0-20%
► Line up the hole (4) and the lug (5).
The arrows (3) point to each other.
► Push the nozzle (1) onto the suction tube (2).
The nozzle (1) engages audibly and no longer needs to be
removed.

Attaching the Nozzle

3
2
3
4
5
English
1
4
1
3
37