Vaisala Indigo500 Serie Guía Rápida página 18

The 8P8C (RJ45) Ethernet connector is located on the inside of the transmitter cover. The
supported standards are 10BASE-T and 100BASE-TX.
SERVICE PORT
PRESS TO ACTIVATE
WEB INTERFACE
ETHERNET
For the M20×1.5 cable gland with split bushing, the cable diameter is 7 mm (0.28 in).
When configuring the non-display transmitter, the Ethernet connector can be
used without taking the cable through the cable gland. Always wire through the
cable gland for more long-term wiring.
When you insert the cable through the gland parts, also remove the split bushing
(3) inside the nylon seal (2) to make the cable fit through the seal. Then place the
bushing around the cable and push it back inside the seal. See the following
figure.
2
3
4
Probe connection terminals and lead-throughs
Before connecting wires or cables, make sure that the transmitter is powered off.
16
M20×1.5
1
VS
+
CH1
RS-485
1 PROBE 2
+
24 VOUT
CH2
+
ANALOG
CH3
INPUT
+
CH4
Figure 5 M20×1.5 cable gland with split
bushing
1 Base of the cable gland
2 Nylon seal
3 Split bushing inside the seal
4 Nut of the cable gland
M212290EN-C