Saris GUARDIAN Serie Manual De Instalación página 2

ADJUST CARRIER TO VEHICLE CONTINUED:
2
Press in on adjusting levers simultaneously and raise rear leg,
then release levers allowing pins to snap into place (Fig. 2).
3
Upper Hook
Note: Hook attachment must be to a supported hinge line - NEVER attach
to glass, unsupported plastic, or roof rack.
4
Upper Hook Upper Hook
Unless otherwise specified in current fit chart,
www.saris.com attach inside strap hooks (Fig. 6)
to bottom edge of trunk at position C1 (ideally)
or C2 (Fig. 5). Attach outside strap hooks above
bend in trunk at position C3. (marked on hook)
6
Outside strap
Inside strap
Side Strap Hook
View from front of rack
Lower
Strap Hook
5
Inside Strap Hook and Hatch Hugger special application:
ONLY IF SPECIFIED IN CURRENT FIT CHART
(available at www.saris.com)
Some vehicles require placing the Inside Strap Hooks in the trunk. To
do so: Loosen straps, place hooks inside trunk, close trunk, pull straps
until hooks brace against trunk wall, and tighten as usual (Fig. 5).
Tighten all straps evenly, removing any
slack. When straps are taut, shake
carrier to check for movement. Retighten if necessary.
ATTACH STRAPS:
Attach Upper-hook straps to top
hinge line of vehicle as shown in
Fig.'s 3 & 4. Always place strap
between car surface and hook.