Pleasant Hearth OFW717RC Manual Del Usuario página 5

ASSEMBLY INSTRUCTIONS
2. Set support ring (F) on a smooth, flat surface
with five sets of predrilled holes on top. Turn
base assembly upside down and align side supports
(G) with corresponding holes. Attach side
supports (G) to support ring (F) by inserting screws
(AA) through predrilled holes in side supports
(G) and into support ring (F) as shown. Tighten
all screws (AA) securely.
Hardware Used
AA M6x10mm Bolt
3. Return assembly to an upright position. Insert
the straight bottom ends of one cross detail (H)
into the openings in the bottom edge of two side
supports (G). Insert the bent top ends into the
openings in the top edge of the same side sup-
port (G) as shown. Repeat using the remaining
cross details (H).
4. Affix poker bracket (A) to the mesh cover (B)
by inserting the poker bracket (A) through the
predrilled hole in the top of the mesh cover (B)
and securing with nut (DD).
Tighten nut with wrench (EE).
Hardware Used
M6 Nut
DD
Wrench
EE
2
G
AA
F
x 10
3
H
4
A
B
x 1
5
G
DD