Using This Unit As A D/A Converter - Pioneer PD-70AE Manual De Instrucciones

> Before Start > Part Names

Using this unit as a D/A converter

1
a
b
2
a Digital Optical Cable, b Digital Coaxial Cable
14
> Install > Playback
You can convert the digital audio from audio devices to
analog, then output them from the ANALOG OUT jacks.
Connections
1. Use either a digital optical cable or digital coaxial cable,
depending on the jacks on the device to be connected, to
connect audio devices.
Switching the source
2. When playing a device connected to the DIGITAL IN
OPTICAL jack, press OPTICAL on the remote controller
to change the source on this unit to "OPTICAL".
OPTICAL
When playing a device connected to the DIGITAL IN
COAXIAL jack, press COAXIAL on the remote controller
to change the source on this unit to "COAXIAL".
COAXIAL
3. Start play on the player.
0 The digital signals that can be input by this unit are linear
PCM signals with a sampling frequency and quantization
bit rate of 192 kHz/24 bit (operation may not be possible
with all connected devices or environments).
Advanced Setup | Others