Aqua Medic Reefdoser EVO 1 Manual De Instrucciones página 5

Calibratable dosing pump with App-control
In the case of the Aqua Medic reefdoser EVO series 1, 3 and 5, the integrated dosing pumps can be controlled
individually. Dosing is done manually or automatically. Each channel can be calibrated individually and
separately. The interval control, which can be operated via the app, allows a wide range of settings - from one-
second to daily.
Features:
- App-control allows a wide range of dosing scenarios
- Flexible installation with wall bracket or stand
- Active signal LED when the pump is working
- Control panel with touch sensors
- Integration of further reefdoser EVO 1, 3 or 5 possible via App
1. Included in shipment
- dosing station
- power supply
Dimensions reefdoser EVO 1: app. 97 x 105 x 127 mm (l x w x h)
Dimensions reefdoser EVO 3: app. 197 x 105 x 127 mm (l x w x h)
Dimensions reefdoser EVO 5: app. 277 x 105 x 127 mm (l x w x h)
Technical data power supply:
Input: 100 - 240 V AC / 50 - 60 Hz
Output: 12 V DC
2. Safety instructions
Fig. 1: Safety instructions:
The dosing pumps (1) are self-priming and have to be installed acc. to Fig. 1. This is the only way to prevent
total emptying of the container (2). It is recommended to keep the tubes as short as possible (water height
max. 2 m = 0.2 bar), however, the tube on the suction side has to reach the bottom of the container (2). To
prevent back flow, take care that the dosing tube does not hang in the aquarium water (4). The water level in
the container (6) has always to be below the end of the dosing tube (5). The water level in the filter / aquarium
(3) is not important when respecting these instructions.
Operation manual ENG
5