Aqua Medic Reefdoser EVO 1 Manual De Instrucciones página 6

The dosing tubes can leak due to wear and tear over the years and then fluid can leak out. Therefore, the dosing
pumps should possibly be mounted over a drip tray (7), the aquarium or filter tank. The tubes must be checked
regularly for clogging, otherwise leakage could occur due to overpressure.
Protect the dosing unit from water splashes and
or high humidity that sometimes occurs e. g. in a cabinet with filter, would damage the unit. In that
case, there is no warranty.
1. This product is for indoor use only. Keep away from humidity, water and salt!
2. Never fill in corrosive or crystallizing liquid.
3. The tube should be filled with liquid before use for calibrating and the flow rate has to be set correctly for
each pump to ensure the dosing accuracy during operation.
4. The pump must not be greased in any way!
When programming, it must be ensured that the pumps do not run more than 15 minutes without
stop. The stop time should be as long as the operating time, otherwise the life span of the pumps
would be reduced.
3. Set-Up and operation
Fig. 2: 1. Button for WLAN integration and LED display 2. Button for manual dosing + LED
4. Pump head 5. Base
Spare parts overview
Pict. No. Item-No.
3 104.201-1
3 104.203-1
3 104.205-1
4 104.144-31
104.144-1
104.144-4
By using the supplied base, the reefdoser EVO 1, 3, 5 can stand or screwed on to a wall.
Operation is only possible manually using the touch panels. All other settings can only be made via the app.
This is available for download on our website: www.aqua-medic.de.
4. Calibrate the pumps
Fill the tubes manually. This is done by tapping the touch panels above the pumps (Fig. 2, No. 2). During
operation, a LED lights up in the housing above the respective pump head.
6. Suction side 7. Pressure side
Name
Front cover reefdoser EVO 1
Front cover reefdoser EVO 3
Front cover reefdoser EVO 5
Pump head
Motor
Power supply 12 V/3 A
humidity (< 80% rel. humidity)! Water, salt water
3. Front cover
6