BMW Retrofit Kit Heated Mirrors Instrucciones De Montaje página 17

Insert both mounting clamps
able metal pins) into the holes on the radio
until the retaining hooks release. Pull the radio out
of the well .
Insert one small screwdriver
in the radio well , press the holding plate
back, pull out the radio well
the cables.
•
Remove the instrument housing
6
Unscrew the screws
and pull the instrument housing
the back. Disconnect the 2-pole plug
instrument lamp from the connecting cable, dis-
connect the cable from the loudspeakers
remove the instrument housing
Remove the mirrors
•
Install the switch for the heated mirrors in the
7
instrument housing (Variation 1)
Determine the installation location and remove
the corresponding cap
Thread the cable through the paneling
above and press the switch
until it clicks into place.
Lay the cable along the wire
ment lamp and fasten it in place with cable ties.
(or four suit-
into each hole
and let it hang on
(10x with plastic washers)
a little bit to
of the
and
.
from the fastening pins
.
from
into the paneling
for the instru-
•
Install the switch for the heated mirrors in the
8
handlebar housing (Variation 2)
Determine the installation location and remove
the corresponding cap
Thread the cable
press the switch
into place.
Lay the cable for the switch along the vehicle
cables to the central electric system in the back.
•
Install the cable assembly
9
Open the central electric system.
Cut open the rubber bushings
new cable assembly
tem. Connect the white plug
.
assembly to the accessories plug
the central electric system.
Lay both connecting cables
rors – along the vehicle cable assembly – to the
front to the paneling holder and there to the right
and left sides of the vehicle.
Note
L
If the switch for the heated mirrors was
installed in the instrument housing (Varia-
tion 1), then the connecting cable
the switch must be laid with the cable for
the left heated mirror to the front to the
paneling holder.
If the switch for the heated mirrors was
.
through the paneling and
into the paneling until it clicks
and lay the
in the central electric sys-
of the cable
and close
for the heated mir-
for
17