The helicopter can fly for approx. 5-6 minutes after a charge time
of approx. 40-60 minutes.
Warning notice: The LiPo battery does not normally heat up while charging.
If it should become warm or even hot and/or changes to the surface begin to appear,
immediately discontinue the charging process!
Now set the helicopter's ON/OFF switch to "ON" (5A). Place the helicopter on the
ground so that its tail points toward you.
The thrust controller (the left controller on the remote control) must point down before
being switched on (5B).
Then set the controller's ON/OFF switch to "ON" (5C). As soon as the remote control
has established contact with the helicopter, the Power LED on the remote control is
permanently illuminated red.
6 TrIM aDJUSTMeNT OF The CONTrOl
The correct trimming is a basic requirement for achieving fault-free flying from the
helicopter. Its adjustment is simple, but it requires some patience and a feel for it.
Please observe the following instructions precisely: Carefully move the thrust control
up and raise the helicopter approximately 0.5 to 1 metre in altitude.
6A
if the helicopter automatically
rotates clockwise...
If the helicopter begins to automati-
cally rotate clockwise quickly or slowly,
rotate the left/right trim adjustment
anti-clockwise until the helicopter no
longer rotates automatically.
5 STarT PreParaTION
6B
If the helicopter begins to automati-
cally rotate anticlockwise quickly or
slowly, rotate the left/right trim ad-
justment clockwise until the helicopter
no longer rotates automatically.
if the helicopter automatically
rotates anti-clockwise ...
17