Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
A-10 / ENGLISH
INSTALL THE BRUSHES
CAUTION !
Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels.
1
Make sure the Vacuum Deck is in the RAISED position. Make sure the Key Switch (A) is off (O).
2
See Figure 2. Loosen both Thumb Screws (AA) slide the Idler Assembly (AB) down and off of the vacuum deck and away from the brush.
4
Slide the brush into the housing, lift slightly, push and turn until it seats. Re-install the Idler Assemblies (AB) and Thumb Screws (AA).
FIGURE 2
A-10 - FORM NO. 56041798 - VacRide
Publicidad
Capítulos
Tabla de contenido
