Preparing The Transceiver - Midland XT-60 Manual De Utilizare

Preparing the transceiver

The radio can be recharged with different type of batteries: here below the
possibilities.
Note: To optimize the recharge process, we suggest you switch off the radio to
recharge it.
Recharging the NIMH batteries (3 x AAA)
Place your transceiver into the cradle of the desktop charger or connect the
USB cable to the proper jack of the radio.
This type of batteries is recharged with a constant current, either you use a
desktop charger or a USB cable; therefore the recharge time depends from
the recharge status and from the batteries capacity.
There's no evidence when the recharge is finished, therefore we suggest you
detach the USB cable from the radio or remove XT60 from the desktop char-
ger cradle once the recharge is complete.
Recharging the NIMH battery pack PB-X6 700mAh
Place your transceiver into the cradle of the desktop charger or connect the
USB cable to the proper jack of the radio.
This type of batteries is recharged with a constant current, therefore a comple-
te recharge takes about 3 hours.
There's no evidence when the recharge is finished, therefore we suggest you
detach the USB cable from the radio or remove XT60 from the desktop char-
ger cradle after 3 hours.
6 | XT60 user's manual