Member's Mark MG3208SLP Manual De Instrucciones página 15

Install Ignitor Battery
9
Unscrew Ignitor Cap from Control Panel.
Place supplied AA battery into the Ignitor
Slot with positive pole facing you.
Position the Cap and Spring over the AA
battery and tighten onto Control Panel.
With the assistance of another person,
10
perform this Electrode Check before
proceeding.
This test will ensure that the Spark Electrode Tips
are properly positioned so your grill lights easily
and properly.
Spark Gap
3/16"
Gas Collector Box
Spark Electrode Tip
Spark Receiver
Be sure all Control Knobs are set to
"OFF" and open the Grill Lid.
Have your assistant stand behind to the
right of the grill and look toward the front
of the grill bowl. Never put your face
inside the Grill Head.
Push the Igniter Cap in and have
assistant watch for a blue spark within
each Gas Collector Box. If a spark is
present the Electrode Tips are properly
positioned.
Side Burner Electrode Check
11
Open side burner lid. Remove plastic
shipping band from burner and pot
support.
Push and turn side burner Control Knob
to HIGH. Look for spark between tip of
electrode and burner.
If you don't see a spark from side burner elec-
trode, adjust gap between electrode and
burner surface to 3/16 in.
Final Grill Assembly Step
When you have finished assembling your
grill be sure that all screws are tightened
for safe operation of your grill.
Ignitor Cap
Spring
Install Cooking Components
12
Place the Savor Plates
Burners.
Place the Cooking Grids on the ledge
above the Savor Plates
Place the Secondary Cooking Rack on
the slots on either side of the Grill
Bowl.
Secondary Cooking Rack
Cooking Grids
®
Savor Plates
WARNING
!
Failure to read and follow the Use and Care
Instructions could result in a fire or explosion
that could cause serious bodily injury, death or
property damage.
15
AA Battery
+
_
Ignitor Slot
® above the
®
.
!