Rotisserie Instruction - Member's Mark MG3208SLP Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Remove all components from the carton.
2.
Attach the Motor Bracket on the outside of the left grill bowl panel. Align the two holes of the Bracket
with the holes on the grill bowl. Tighten securely using two Screws #10-24x3/4" UNC, Plain Washers
and Nuts provided.
Rot. Screw #10-24x3/4" UNC x2
Rot. Washer x2
Rot. Nut #10-24 x2
3.
Slide the Spit through the piece of meat or poultry and the Holding Forks onto each end of the Rotisserie
Spit. Adjust spacing between Holding Forks to accommodate your food, then tighten the Thumbscrews
to keep the Holding Forks in position. Slide the Collar and Bushing onto the threaded end of the Spit.
Do not tighten the Collar Thumbscrew until the Rotisserie is placed into your grill. Last, screw the
Handle onto the threaded end of Rotisserie Spit as shown.
Rot.Thumbscrew 3/8"x1/2" x3
Rotisserie Instructions
Motor Bracket
Rot.
Screw#10-24x3/4"
UNC with
washers and nuts
T hu mbsc rew
3/8"x1/2"
Spit
23
Washer
Outside of left grill
bowl panel
Handle
T hu mbsc rew
3/8"x1/2"
Collar
Holding Forks
#10-24 Nut.
Bushing

Publicidad

Tabla de contenido
loading

Tabla de contenido