Monitor Function; Scan Function - Midland XT-30 Manual De Usuario

MON/SCAN

Monitor function

When this feature is activated, the radio can receive very low and weak signals.
This is very useful when you need to talk but the distance is as far as the ma-
ximum range possible; with the monitor feature you can extend the coverage
of the radio.
The disadvantage is the reception of loud background noises.
Activation/Deactivation: Keep pressed MON/SCAN till the display shows
"Rx".

SCAN function

The SCAN mode monitors the busy channels.
It is used to check the traffic radio on all the channels before transmitting and
allows the unit to stop on a channel that someone is talking on. When the radio
stops on a busy channel, the scan will resume after about 5 seconds.
To activate the SCAN function
1. Push MON/SCAN.
2. While the scan mode is operating, if you push the ▲/▼ controls you can
choose the scanning direction.
To deactivate it:
Press MON/SCAN or PTT.
Recharge
When the batteries are discharged, the icon
sary to start the recharge as soon as possible. The icon blinks only if the radio
is turned on.
ATTENTION
Alkaline batteries cannot be recharged.
Do not recharge the radio without the rechargeable batteries.
For the very first time, we recommend to recharge the radio for 10/12 hours.
10 |
starts blinking: it is neces-
XT-30 instruction guide