ANSMANN 1001-0080 Manual De Instrucciones página 14

Advanced functions
Note: If you wish to select the same mode for several rechargeable
batteries, first insert the rechargeable batteries and then hook up
the power supply. Then make the desired settings. These settings will
be used for all occupied charging compartments. But you can also
occupy and set each charging compartment individually.
• After inserting the rechargeable battery, you have 8 seconds to
select the desired mode and charging current.
• The set mode and charging current are marked at the edge of the
display by an arrow each. When the arrows flash, you can make
settings.
• The set mode will begin when no button is pressed for 8 seconds
and the arrows at the edge of the display are permanently lit.
• If you wish to make any subsequent changes:
− Use the CHANNEL button to toggle to the charging
compartment in question.
− Press and hold the MODE button for 4 seconds until the arrows
begin flashing.
Note: The values recorded up until this point (mAh indicator
and timer) are reset to 0.
Button functions
Button Function
MODE Change mode
CHANNEL Show status for next charging compartment
Note: Only occupied charging compartments can be
shown.
CURRENT Change charging current
USB connection
• The USB connection serves as a voltage source with 5 V and max.
2000 mA.
• The USB connection and charging compartments can be used at
the same time.
Deutsch |
14
English | Français | Español | Português
Svenska | Italiano | Nederlands