JBL TempSet basic Indicaciones Para El Montaje página 9

When mounting on a metal air screen: A power drill or a rechargeable screw drill with 4.5 and
8 mm HSS drill bits, a jig saw with a metal saw blade, screwdriver, file for metal.
When mounting on a wooden panel: A power drill with a 40 mm hole saw, screwdriver and file
or sandpaper for wood.
The mounting procedure described in the following can be performed by anyone if the instruc-
tions are followed accurately. You do not need to be a specialist:
1. Stick the enclosed self-adhesive drilling and sawing template onto the upper air screen or
the upper wooden panel of the terrarium from the outside in the spot where the TempSet is
to be mounted.
2. Produce the round cut-out (40 mm) and the holes for the mounting screws in accordance
with the instructions on the template. Deburr the edges with a file or sandpaper and re-
move the template. When mounting on a wooden panel, drill a cut-out of only 40 mm with
the hole saw. You do not need to drill the small holes for the mounting screws.
3. Insert the special socket through the large cut-out (40 mm) from the outside to the inside.
Mount the cover panel as follows:
When mounting on a metal air screen: Screw the two screws supplied with the kit through
the predrilled holes in the air screen into the thread of the cover panel from the inside and
tighten them.
When mounting on a wooden panel: Screw two self-cutting wood screws of a fitting size
through the two small holes of the cover panel from the outside.
3 a Instead of mounting the cover panel with screws, the cover panel can also be mounted on
both the air screen and the wooden panel with a so-called MS Polymer adhesive. Adhe-
UK