Wolf DD30 Guia De Instalacion página 10

Installation
Installation
INTERNAL BLOWER
To mount the internal blower on the front or rear of the
downdraft:
1 Rotate the blower box so the 6"
is properly located, then disconnect the cable from
the downdraft receptacle and connect it to the blower
receptacle. Refer to the illustrations below.
Once the blower connection is made and the discharge
2
properly located, secure the blower to the downdraft
using the four screws provided.
DISCHARGE
Left, right, or bottom discharge Blower connection
10 | Wolf Customer Care 800.222.7820
round discharge
(152)
DOWNDRAFT BLOWER
RECEPTACLE RECEPTACLE
To mount the internal blower on the front of the down-
draft but discharge from the rear:
Remove the blower from the blower box.
1
2 Mount the blower motor to the downdraft using the
two screws provided.
3 Remove the blower plug from the downdraft receptacle
and insert it into the blower receptacle. Refer to the
illustration below.
4 Once the plug is installed and the blower secure, install
the blower box to the downdraft using the four screws
provided.
5 Remove the 6" collar from the blower box and the
(152)
solid cover from the rear of the downdraft, then rein-
stall the 6" collar on the rear and the solid cover on
(152)
the blower box. Refer to the illustration below.
DOWNDRAFT
RECEPTACLE
BLOWER
RECEPTACLE
Blower mounting
COVER
COLLAR
Install cover