Downdraft Ventilation; Product Information - Wolf DD30 Guia De Instalacion

Downdraft Ventilation

Product Information

Important product information, including the model and
serial number, are listed on the product rating plate. The
rating plate is located next to the blower housing on the
front side of the downdraft, below the countertop. Refer to
the illustration below.
If service is necessary, contact Wolf Factory Certified
Service with the model and serial number. For the name of
the nearest Wolf Factory Certified Service or for questions
regarding the installation, visit the Product Support section
of our website, wolfappliance.com, or call Wolf Customer
Care at 800-222-7820.
RATING PLATE
Rating plate location
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
a) Installation work and electrical wiring must
be done by qualified person(s) in accor-
dance with all applicable codes and stan-
dards, including fire-rated construction.
b) Sufficient air is needed for proper com-
bustion and exhausting of gases through
the flue (chimney) of fuel burning equip-
ment to prevent back drafting. Follow the
heating equipment manufacturer's guide-
line and safety standards such as those
published by the National Fire Protection
Association (NFPA), and the American
Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the
local code authorities.
c) When cutting or drilling into the wall or
ceiling, do not damage electrical wiring
and other hidden utilities.
d) Ducted fans must always be vented to the
outdoors.
wolfappliance.com | 3