Before Use; Charging The Battery Pack; Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level - Parkside PAAS 12 A2 Traducción Del Manual De Instrucciones Original

Before use

Charging the battery pack

CAUTION!
► Always unplug the appliance before you
remove the battery pack
the battery pack to the high-speed battery
charger .
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The storage climate
should be cool and dry and the ambient tem-
perature should be between 0°C and 50°C.
♦ Connect the battery pack
battery charger .
♦ Insert the power plug into the socket. The
control LED lights up red.
♦ The green control LED
charging process is complete and the battery
pack is ready for use.
♦ Push the battery pack
ance.
♦ You should always switch the high-speed
charger off for at least 15 minutes between
successive charging processes. Also disconnect
the power plug from the mains power socket.
│ GB │ IE
■ 8
from or connect
to the high-speed
indicates that the
back into the appli-
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦ Click the battery pack
Removing the battery pack
♦ Press the release buttons
battery pack .

Checking the battery charge level

♦ Press the safety lock-out
OFF switch to check the charge level of the
battery. The status/remaining charge will be
shown on the battery charge level display
as follows:
RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery

Attaching/removing the grip bracket

NOTE
► The grip bracket
removed while the saw blade
Attaching the grip bracket (see fig. A–C)
♦ Push the grip bracket
the base plate and onto the appliance.
Removing the grip bracket
♦ Press the release
bracket forwards out of the guides.
into the handle
and remove the
and the ON/
cannot be attached/
is attached.
over the guides on
and pull the grip
PAAS 12 A2
.