Transport And Handling; Noise Level; Vibrations; Transport And Handling - breviglieri MekFarmer 170 Manual De Empleo Y Mantenimiento

MekFarmer 170
A
Version cm inch
300 300 118
350 348 137
400 396 156

2.8 NOISE LEVEL

• Acoustic pressure LpAm (A): dB 82.1
• Acoustic power LwA (A): dB 98,6
CAUTION
Danger of loud noise when operating the machine.
ALWAYS WEAR EAR PROTECTORS TO PROTECT YOUR
HEARING

2.9 VIBRATIONS

During its normal working, the machine does not transmit
significant vibrations to the tractor and therefore to the
operator. These vibrations are less than 8,2 ft/s
operator's upper limbs and less than 1,6 ft/s
ting part of the operator's body.

3 TRANSPORT AND HANDLING

3.1 SAFETY WARNINGS

NOTE
READING THIS CHAPTER IMPLIES THAT, FOR A SAFE USE OF
THE MACHINE, WHAT IS CONTAINED IN THE PARAGRAPH "2.1
GENERAL SAFETY WARNINGS" HAS BEEN FULLY UNDERSTO-
OD.
DANGER
Never allow access to unauthorised and/or unquali-
fied staff in the area of handling and packaging of the
machine.
The handling and packaging phases of the machine
must be carried out by staff specialised in operating
cranes and forklift trucks.
CAUTION
Always use CE lifting equipment (straps, cranes, forklift
trucks..) for handling the machine and the packaging.
The lifting equipment for the machine or the packaging
must have a capacity higher that the load weight.
ALWAYS WEAR GLOVES TO PROTECT YOUR HANDS
ALWAYS WEAR PROTECTIVE CLOTHING TO PROTECT
YOUR BODY
B C
cm inch cm inch
125 49 152 60
125 49 152 60
125 49 152 60
for the
2
for the sit-
2
ALWAYS WEAR SAFETY BOOTS

3.2 HANDLING

3.2.1

HANDLING OF THE MACHINE

ALWAYS WEAR A HELMET
Weight
Version Kg lb
300 1060 2337
350 1170 2579
400 1290 2844 crane/lifting straps
The weighs refers to the machine without roller.
Handling machine without roller
FIG. 5
Make sure that the zone in which the operations take place
is uncluttered and that there is a sufficient «escape route»,
i.e. a clear and safe zone to which the operators can qui-
ckly move if the load should fall.
CAUTION
When handling with a forklift insert the forks between
the blades. Place the forks under the rotor.
Beware of the sharp edges as they can damage the
lifting straps.
To lift the machine with roller you have to hitch it in diffe-
rent places: a lift point is indicated on the machine, near
the upper three-point hitch. Hitch the straps on the scraper
holder bar too. Check the balance and the positioning of
the load on the forks in case of a forklift and of the as-
sembly hook-straps-machine in case of a crane. When han-
dling, loads must not be hoisted no more than 8 inches
from the ground
Hoisting equipment
crane/lifting straps
crane/lifting straps
G
39