Panasonic CS-E9HKEA Instrucciones De Funcionamiento página 5

TO SELECT FAN SPEED
FAN SPEED
(5 OPTIONS)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
TO ADJUST AIRFLOW
DIRECTION (5 OPTIONS)
• Keeps the room ventilated.
• If AUTO is set, the louvers swing left/right and up/down
automatically.
• In heat mode, the air blows horizontally for a while, then
starts to blow downwards and the airfl ow louvers start to
swing left/right after the temperature rises.
TO ENJOY CLEAN AIR
• To provide fresh air effect by producing negative ions.
- Ion operation could be activated independently.
Press to stop the operation.
OFF/ON
TO ENJOY QUIET
QUIET
ENVIRONMENT
• This operation reduces airfl ow noise.
TO ACHIEVE TEMPERATURE
POWERFUL
QUICKLY
• Supersonic air purifying device (super alleru-buster)
operates automatically once the unit is switched on.
QUIET POWERFUL
• , and
all modes and can be cancelled by pressing the
respective button again.
QUIET POWERFUL
• and can not be selected at the
same time.
can be activated in
TO SET THE TIMER TO SET THE TIMER
• To turn ON or OFF the unit at a preset time.
ON
1
OFF
Select ON or Set the time.
OFF timer.
• To cancel ON or OFF timer, press
press .
CANCEL
• When ON Timer is set, the unit may start earlier (up
to 30 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the remote
control and repeats daily once set. For clock setting,
please refer to Remote Control Preparation at back
cover.
• If timer is cancelled manually or due to power failure,
you can restore the previous setting (once power is
SET
resumed) by pressing
OPTIONAL SETTINGS OPTIONAL SETTINGS
Press and hold for 5 seconds to dim or
restore the unit's indicator brightness.
Press and hold for approximately 10
seconds to show temperature setting in
°C or °F.
Press and hold for approximately 5
seconds to show 12-hour (am/pm) or
CLOCK
24-hour time indication.
RC Press to restore the remote control's
default setting.
RESET
AC
, Not used in normal operations.
SET
RESET
Set the temperature 1°C higher in cool mode or 2°C
lower in heat mode than the desired temperature to
achieve a 10% power saving.
Use curtains to screen off sunlight and outdoor heat to
reduce power consumption during cool mode.
TIMER
2
SET
Confi rm.
ON
or then
OFF
.
5