Assembly - Leggett & Platt LP 50 II Manual Del Usuario

To assemble adjustable base, complete the following procedure:
STEP 1
Place adjustable base shipping container on solid,
level surface. Remove top section of shipping
container. Remove packing material. Carefully, lift
adjustable base out of bottom section of shipping
container and place on clean surface. Allow for
enough space to unfold base in setup area.
STEP 2 STEP 2
Raise the top section of the adjustable base and Raise the top section of the adjustable base and
remove hardware / leg boxes. remove hardware / leg boxes.
STEP 3
Remove cotter pin and clevis pin from hinge (one on
each side) and fold adjustable base out flat (FIGURE 1).
FIGURE 1
REMOVE
CLEVIS PIN
REMOVE
COTTER PIN
STEP 4
When base is flat, reinsert clevis pin and cotter pin (one on each side)
(FIGURE 2).
FIGURE 2
REINSERT
CLEVIS PIN
REINSERT
COTTER PIN
BASE IN FLAT
4
POSITION

ASSEMBLY

DUE TO RISK OF INJURY, TWO ADULTS
ARE REQUIRED TO HANDLE AND MOVE
KEEP HANDS AND FINGERS CLEAR OF
HINGES DURING UNFOLDING OF BASE.
IMAGES SHOWN MAY DIFFER FROM ACTUAL
WARNING
!
ADJUSTABLE BASE.
WARNING
!
PINCH POINT!
NOTE
PRODUCT.