Leggett & Platt LP 50 II Manual Del Usuario página 8

ASSEMBLY
STEP 10
WARNING
!
Rotate base over onto its legs.
DUE TO RISK OF INJURY, TWO ADULTS
STEP 11
ARE REQUIRED TO HANDLE AND MOVE
Operate remote control to verify base functions properly.
ADJUSTABLE BASE.
If base does not operate, see the Troubleshooting
section.
STEP 12
Lower base to flat position.
STEP 13
Install the mattress retainer. Place one end of the mattress retainer into
the outside hole of the left insert and place the other end into the outside
hole of right insert (FIGURE 7).
MATTRESS
FIGURE 7
RETAINER
STEP 14
Place mattress on base to complete assembly.
8