Soundoff Signal nROADS ENRBCSHM Serie Instrucciones De Montaje página 3

"REAR" needs to face
Magnets x3
the rear of the vehicle
MAGNET MOUNT
Damages or injury may occur from improper use of a lighting product intended for vehicle use.
recommended to use secure, permanent mounting for maximum safety. In some instances, a
vehicle retention is based on magnets on the lighting product to the vehicle's steel/ferrous flat
metal components) is offered. The effectiveness of magnet mounting is reduced by factors
mounting location, and also with newer vehicle non-magnetic metal such as aluminum. Due
to the potential for low effective magnetic mount retention, it is recommended to use magnets
for stationary vehicle use. High driving speeds, rapid accelerations, or rapid decelerations
(including accidents or rough road conditions or weather related conditions) may cause a
3.
CIG PLUG
WARNING
!
Auxiliary vehicle lighting products, when used on highway use vehicles, are always
more temporary vehicle attachment, such as optional magnet mounting (lighting product
that include the contour, texture, curvature, snow, ice, and general cleanliness of the
magnet mounted light to unexpectedly detach from the vehicle.
It is the sole responsibility of the user to ensure proper mounting and safe operating
conditions and end user awareness of the safe operating conditions.
nROADS Mounting Instructions
Magnet Mount:
1. Locate surface where beacon will be mounted.
2. Place beacon with the "REAR" facing the rear of
the vehicle. This is important for specific modes.
Cig Plug Operation:
1. See Cig Plug diagram at left for POWER ON/OFF
and PATTERN SELECT switch locations.
2. Turn beacon ON by pressing the POWER ON/OFF
switch to the ON position.
PATTERN
3. With beacon OFF, press and hold PATTERN
SELECT switch for 1 second until you see the
beacon flash the new pattern and release.
4. Holding the PATTERN SELECT switch for >5
seconds while the beacon is ON will reset the
POWER ON/OFF beacon to pattern #0.
nROADS Beacon_9-32Vdc 0318