Factory Reset - yellow jacket 52030F Instrucciones De Operación

FACTORY RESET

To restore the settings in the thermal imager back to the original factory
values, do the following:
1. Press the up/down button to select the
2. Press the SET button to enter the Factory
3. Press the up/down button to select Yes.
4. Press the SET button to confirm.
5. Press the back button to exit the current
FORMAT SD CARD
Formatting the SD card will delete all information from the SD card
To format the SD card:
1. Press the up/down button to select the
2. Press the SET button to enter the Format
3. Press the up/down button to select Yes.
4. Press the SET button to confirm.
5. Press the back button to exit the
Factory Reset option in the settings
menu.
Reset submenu.
menu.
Format SD option in the settings menu.
SD submenu.
current menu.
AUTO SAVE
TO TURN ON OR OFF AUTO SAVE
1. Press the up/down button to select the
2. Press the SET button to enter the Auto
3. Press the up/down button to select
4. Press the SET button to confirm.
5. Press the back button to exit the
Note: Do not remove or insert the SD card while saving or viewing images.
If the SD card is replaced while the thermal imager is in use, restart the
thermal image
Auto Save option in the settings menu.
Save submenu.
On or Off.
current menu.