Tripp-Lite B126-1A1 Manual Del Proprietário página 12

Extender Kit with Remote/Repeater Installation
12
Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the last remote/
repeater unit to the RJ45 INPUT port of the B126-1A1 or B126-1A1-WP
remote receiver unit.
13
Connect a monitor to the HDMI OUTPUT port on the remote receiver unit
using a Tripp Lite P568-Series HDMI Cable.
14
Connect the external power supply to the remote receiver unit and
plug it into a Tripp Lite Surge Protector, PDU or UPS. The green LED
illuminates to indicate the unit is receiving power from the external
power supply. The orange LED illuminates to indicate the unit is
connected to a powered ON remote/repeater unit.
15
Turn on the power to the HDMI source. The orange LED on the local unit
illuminates to indicate a signal is being received from the source.
16
If necessary, use the Equalization control on the remote/repeater unit(s)
and remote receiver unit to adjust the video image.
Note: An improper Equalization setting can cause the monitor not to display a
picture at all. Try each Equalization setting until an acceptable picture is displayed.
17-07-081-933731.indb 12
12
8/2/2017 8:57:24 AM