Carico Ultra-Tech WH-750 Manual De Instalación página 9

HEAD
SUMP
Maximum PSI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .120 psi
Micron Rating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10 Microns
Inlet/Outlet Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1"
NOT FOR USE ANYWHERE POTABLE WATER SOURCE IS
MICROBIOLOGICALLY OR CHEMICALLY UNSAFE.
1. Remove system from its shipping carton and check to see that all components are
included. (See component list).
2. Connect the two Quick connect Threaded Connectors to the inlet and outlet sides of the
Pre-Filter's Head
3. Unscrew the Pre-Filter's Sump from the Head, insert one of the cartridges
after removing its wrapping. Screw Sump back onto the Head making sure that the
"O" ring is properly seated to avoid any leaking. Be sure to properly tighten the Sump
to the Head.
4. Measure out the pipe and fittings from the incoming water supply and connect to the
stop valve (included) level with the inlet tube on the Backwash Valve.
(See photo/diagram "A")
Cut a small piece of pipe and attach the stop valve to the quick connect fitting on the
inlet side of the pre filter. Using another small piece of pipe attach the outlet side quick
connect fitting of the pre filter to the quick connect union adapter. Attach the union
adapter to the inlet tube on the Backwash Valve.
5. Follow steps 1through 5 in Step "B" of your installation instructions.
Note: When backwash procedure begins, press and hold the red button on top of
pre-filter to release any air that may be in the pre filter unit.
PRE-FILTER SYSTEM COMPONENT LIST
One (1) Housing containing (1) Head and (1) Sump
Two (2) Cartridges
Two (2) Quick Connect Threaded Connectors in 1"
One (1) Quick Connect Union Connector in 1"
One (1) Stop Valve (Ball Valve)
PRE-FILTER SPECIFICATIONS
PRE-FILTER SYSTEM INSTALLATION:
5