Cutting Height Adjustment - sunjoe MJ502M Manual Del Operador

3. After assembling the handle, line up the holes at the lower
end of each handle arm with the short posts that extend
from the side plates of the mower base (Fig. 3).
Fig. 3
4. Pull both sides of the lower handle bars over the posts
on the mower body. Press inward on the handle bars to
ensure a secure fit over the posts.
Fitting the grass catcher
1. Hook the pre-assembled grass catcher onto the mower
body by connecting the hooks to both ends of the steel
shaft (Fig. 4).
Fig. 4
Hook
Steel shaft
Handle bars
Post
NOTE: If you have any questions, please call the Snow Joe
Sun Joe
(1-866-766-9563) for assistance.
Operation

Cutting height adjustment

Hook
6
2. Secure the locking strap on the grass catcher to the center
bar on the lower handle of the mower. Adjust the strap to
an appropriate height so that the grass catcher does not
rub against the ground while mowing or transporting the
unit (Fig. 5).
Fig. 5
customer service department at 1-866-SNOWJOE
®
1. The cutting height of the 20 in. (50.8 cm) reel mower can
be adjusted from 1.2 in. to 2.4 in. (30 mm to 61 mm) by
moving the 9-position height adjustment levers to the
desired setting. The height adjustment levers are located
next to the smaller wheels.
2. In order to set the mower to its lowest cutting position,
pull the adjustment levers on both sides, one at a time,
and set them to position A (Fig. 6).
Locking strap
+
®