Mato DF-LS Instrucciones De Empleo página 10

High pressure hose
Nozzle
Checking for loose
connections
Legibility and availability of
information
6 Tips for fault diagnostics:
Symptom
The grease gun is not
producing any grease.
There is air in the grease
Grease is escaping from the
nozzle.
7 Specifications:
Pressurised air pump pneuMATO
Pressure transfer
Max. delivery pressure at 8 bar compressed air
connection.
Air pressure min./max.
Flow rate:
Volume level:
Fluid temperature (lower temperatures are
possible, depending on the fluidity of the grease)
Thread
Air connection
Grease outlet
Weight
Lubricants:
Grease up to the consistency of 3 (NLGI / Class 2 according to DIN 51818) can be used. Pastes
without lubrication properties (with abrasive sandpaper parts) must not be used with this device.
8 Disposal
After termination of use the device is to be disposed of in an environmentally
friendly manner in accordance with applicable statutory provisions.
Grease-tainted parts do not belong in the dustbin!
The applicable regulations for the registration, installation and operation of
equipment for handling of substances hazardous to water are to be strictly observed by the
operator (such as, e.g., Federal Water Act, German Ordinance on Exposure to Substances
Hazardous to Waters and Technical Rules and Regulations for Flammable Liquids).
10
Benzstr. 16-24 / 63165 Mühlheim am Main / Tel.: +49(0)6108-906-0 Fax: +49(0)6108-906-120
Before each Annually
use
X X
X X
X
X
Possible cause
Grease cartridge is empty.
Cartridge is not tightly screwed
Compressed air connection greater
than 8 bar.
MATO GmbH & Co. KG
Pneumatic one-handed grease gun manual
Observe manufacturer's information
and the operator's hazard
assessment
Rectification
Replace grease cartridge.
Tightly screw cartridge in
place
Reduce pressure.
DF 500
1:60
480 bar
3 – 8 bar
1 ccm/Hub
ca. 85
-10° C bis +50° C
G 1/4"
R 1/8"
1.8 kg
DF-LS
X
dB(A)