Echo PAS-210 , 211 Instrucciones De Instalación página 2

2
-
INSTALL U HANDLE AND HARNESS RING
Tools Required: 8 mm x 10 mm Open End Wrench, Screwdriver,
4 mm Hex Wrench, 19 mm Wrench.
Parts Required: U-Handle Assembly, Harness Clamp, Lower Handle
Bracket, Lower Handle Bracket Clamp, 8 mm Square
Nut, 8 mm x 55 mm Long Hex Head Bolt, 8 mm Flat
Washer, 5 mm x 30 mm hex socket bolts (3), Plastic
Cable Clamps (2).
1. Close choke and remove air filter cover.
2. Disconnect two (2) ignition stop leads (A).
3. Remove inner throttle linkage cable from carburetor swivel (B).
4. Remove throttle cable from adjustment fixture (C).
5. Loosen two (2) bolts (D) (1 bolt on SRM-230/231) and pull drive
shaft assembly from clutch case.
6. Loosen two (2) rear handle screws (E) and pull rear handle (F) from
the drive shaft assembly.
7. Loosen four (4) screws (G) and remove front handle.
8. Insert square nut (H) in lower handle bracket (I) and place bracket
on drive shaft 483mm (19 in.) from engine end of drive shaft.
9. Secure with lower handle bracket clamp (J) and three (3) 5mm x
30mm hex socket bolts.
10. Position harness ring 375mm (14-3/4 in.) from engine end of drive
shaft assembly. DO NOT tighten at this time.
A
B
C
G
F
H
I
J
483 mm
(19 in.)
375 mm
I
J
(14-3/4 in.)
D
E
ENGINE
END