Technical Data - Q-Connect QCCb4 Manual De Instrucciones

1 Cover
2 Edge guide
3 Punching Channel
4 Punching Handle
5 Binding Mechanism
6 Binding Handle
7 Margin Depth Control
8 Waste tray
edge alignment
The adjustable Edge Guide allows pages of various sizes to be
accurately aligned for the best punching results. Press down and
move the edge guide left or right and release it at the required
position. Test punching the scrap sheet and re-adjust if necessary.
PunChing
With the Punching Handle in the vertical position, align sheets or
covers and insert the edge to be bound into the Punching Channel
and ensure they are aligned to the Edge Guide. The lid becomes a
rigid paper support when opened. You may let the inserted sheets
rest against it. Pull the Punching Handle all the way down.
The QCCB4 can punch max. 25 sheets of 80 gsm paper at once.
Punch max. 2 plastic covers at a time. To minimize the fatigue of
the QCCB4, we recommend to punch max. 20 sheets every time.
Move the punching Handle upwards again and remove the
punched document.
margin dePth Control
The QCCB4 comb binder is equipped with a Margin Control knob
for improved document reading and paper strength. It can be
turned either clockwise or counter-clockwise to suit the size of
the document being bound. Generally a small margin depth is
required for small comb sizes and a larger margin depth is
recommended for larger comb sizes.
reCommended setting
Depth 2: 6mm - 8mm.
Depth 3: 10mm - 12mm.
Depth 4: 14mm - 18mm.
Depth 5: 20mm and more.
binding
Place a plastic comb with the side to be opened upwards onto the
Binding Mechanism. Pull down the Punching Handle so far that the
comb is opened enough.
Position the punched sheets vertically in the open comb. Locate
the punched holes over the open comb fingers and rotate the
sheets forward onto the comb. When all the sheets are loaded
onto the plastic comb, release the Binding Handle to its original
position to close the plastic comb completely. You can now
remove the bound booklet and enjoy your finished work.
3
emPtying the waste tray
Take out the waste tray from the front side of the machine. For best
results, empty the tray regularly.
storage
Close all lids and move handles to rest position.
general safeguards
Place the comb binder on a secure and stable work table to
prevent it from falling and causing personal injury and damage to
the machine.
Use the machine only for its intended purpose. Always test the
machine with some scrap paper before punching the final docu-
ment.
When punching plastic covers, we recommend to punch the cover
with a sheet of paper on both sides.
Empty the waste tray regularly.
Lift the machine from the bottom, not from the lids or handles.
Unauthorised maintenance is not allowed.
teChniC al data
Punching capacity: 25 sheets (80gsm).
Number of punches: 21.
Binding capacity: 450 sheets.
max. Document size: 360mm.
Max. Binding Comb: 51mm.
adjustable edge guide
Variable punching margin: 2mm - 5mm.
t
W W W . Q - C O N N E C T . C O M