IRSAP 1033M1119 Manual De Instrucciones página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 5
Children between 3 and 14 years of age and persons with reduced physical, sensory or mental capacities, or who lack experience or the necessary
knowledge can use the towel warmer on condition that it has been positioned or installed in the normal position contemplated and they have been
instructed and trained in its safe use and are aware of the potential risks.
Children under the age of 14 must not connect the power plug, nor adjust or clean the appliance.
Children and persons with reduced physical, sensory or mental capacities, or who lack experience or the necessary knowledge must not perform
cleaning or routine maintenance of the towel warmer.
It is absolutely prohibited:
To power the heating element control before having checked the correct installation of the thermostat on the towel warmer
-
To cut the power supply cable to disconnect the appliance
-
To damage the power supply cable. If the power cable is damaged the complete electric heating element must be repaired or replaced by the
-
manufacturer or by their technical assistance service, or by a qualified person authorised by the manufacturer, so as to prevent any risk.
WARNING:
Before powering the electric heating element, make sure that the towel warmer is completely filled with water.
-
During operation of the electric heating element, the complete filling of the towel warmer with water and the free expansion of the internal liquid
-
content must be constantly guaranteed, so the valve and the lockshield must never be turned off at the same time.
DURING OPERATION, TOWEL WARMER PRESENTS HOT SURFACES, SOME PARTS CAN GET VERY HOT, AND CAUSE BURNS UNLESS
-
PARTICULAR CARE IS TAKEN.
During operation it is normal for the last two pipes at the bottom and the first one at the top to remain lukewarm.
-
Only fabrics washed with water can be dried on the towel warmer.
-
Do not use corrosive or abrasive products or solvents to clean towel warmer or the plastic parts that contain the electrical parts.
-
1- ON/Stand-by
button
(1)
By simply pressing the
ON/Stand-by
When the device goes into "Stand-by" mode, the buzzer sounds twice for 0.5 seconds, and when the device goes into "Comfort" mode, the buzzer
sounds once for 1 second
LED off
Red LED lit
Blue LED lit
Red/blue LED blinking
2-
Knob
(3)
Rotation: used to set the desired liquid temperature.
• Clockwise rotation = increases the temperature up to 70°C;
• Counter-clockwise rotation = decreases the temperature down to 30°C.
Button: pressing the knob activates the "Boost" function. (The heating element is activated at maximum power for 2h)
"Boost" mode activated
When the 2 hours are up, the regulator returns to the previous mode.
24-hour timer:
to activate this function, it is necessary to press the knob for 3
maximum temperature than can be reached is 70°C). When the time is up, it returns to "Comfort" mode for 22 hours, then returns to "Boost" mode for
another 2 hours, and continues indefinitely. During the first cycle, "Comfort" mode lasts 21 hours.
"Boost"
mode for 2 hours (green LED blinking) (2)
"Comfort"
mode for 22 hours (green LED) (2)
12-hour timer:
to activate this function, it is necessary to press the knob for 5
maximum temperature than can be reached is 70°C). When the time is up, it returns to "Comfort" mode for 10 hours, then returns to "Boost" mode for
another 2 hours, and continues indefinitely. During the first cycle, "Comfort" mode lasts 11 hours.
"Boost"
mode for 2 hours (yellow LED blinking) (2)
"Comfort"
mode for 12 hours (yellow LED) (2)
in accordance with article 14 of the Directive 2012/19/EU of 07/07/2012 on waste electrical and electronic equipment.
• The symbol shown above, present also on the equipment, indicates that it has been placed on the market and that, when the user decides to get rid of
it, it must be disposed of in separate waste collection (including all the components, sub-assemblies and consumer materials which are an integral part
of the product).
• For information on the systems for collecting these appliances, please contact the company or another subject enrolled in the various National Registers
for other countries in the European Union. Waste produced in the home (or of similar origin) may be consigned to systems for the separate collection of
urban waste.
• When buying a new appliance of an equivalent type, it is possible to hand over the old equipment to the seller. The seller will then contact the subject
in charge of the collection of the equipment.
• The appropriate separate collection of the scrapped equipment and the subsequent operations of processing, recovery and environment-compatible
disposal, allows the avoidance of potential negative effects on the environment and on human health, while favouring the recycling and recovery of the
component materials.
The unauthorised disposal of the product by the user entails the application of the sanctions contemplated under the national approval of Directives
2011/65/EU, 2008/98/EC and 2015/1127/EU.
METHOD OF USE AND OPERATION
button it is possible to change from "Stand-by" to "Comfort" mode and vice versa.
"Stand-by"
"Comfort": heating element on
"Comfort": heating element off
Error message, the heating element is deactivated, contact the service centre
(red LED
blinking) (2)
INFORMATION FOR USERS
To interrupt the
"Boost"
function, just press the knob
seconds. Heating starts for 2 hours, irrespective of the set temperature (the
seconds. Heating starts for 2 hours, irrespective of the set temperature (the
again.

Publicidad

Tabla de contenido
loading

Tabla de contenido