Operating Instructions; To Use Emergency Channel 9 - Maxon MCB-45W El Manual Del Propietario

OPERATING INSTRUCTIONS

Once you have properly wired your new CB and
connected the antenna, you are ready to adjust your
radio for optimum reception and voice transmission.
For proper operation, the radio's microphone must be
connected to the unit. Insert the microphone plug
into the microphone jack (MIC). Push inward and
tighten the locking nut on the end of the cord. When
removing the microphone, unscrew the locking nut
and gently pull out the microphone plug
1) Turn the off/on-volume control clockwise and
adjust to a comfortable volume level.
2) Use the CB/Weather channel control knob
to select the desired channel.
3) Adjust the squelch control knob to reduce any
undesirable background noise when no signal
is being received. To do this, select a channel
where no signals are present, or wait until
signals cease on your channel. Then, rotate
the squelch control knob clockwise to a point
where the background noise ceases.
NOTE: When the squelch is set properly, the radio
speaker will remain quiet until a signal is received.
In order to receive weak signals, do not set the
squelch too high.
4) Re-adjust the volume to a desired listening level.

To use Emergency Channel 9

Press the CH9 selector. "9EMG" will display on the
LCD. Press CH9 again to return to normal CB mode.
11