System Settings - RuarkAudio R3 Compact Manual De Instrucciones

System settings

Bass and treble
MENU > System > Audio > Bass or Treble level
Loudness
Loudness automatically boosts the treble and bass
frequencies at lower volumes.
MENU > System > Audio > Loudness
3D sound
3D widens the stereo sound stage and creates a more
immersive and involving sound.
MENU > System > Audio > 3D
Date and time
MENU > System > Date and time
The time and date are automatically synchronised with
national time signals broadcast over DAB, network
and FM (FM time synchronisation may not always be
available).
You can also set the time manually by turning auto
update off and change the time and date format.
Display brightness
MENU > System > Brightness
Independently adjust the brightness of the display when
your R3 is on and in standby.
When the brightness is set to 0 the display will
automatically switch off after a few seconds. The display
will then briefly illuminate whenever any key is pressed.
You can also adjust the standby brightness when your R3
is in standby by pressing
Language
MENU > System > Language
Change the menu language.
Software update
MENU > System > Software update
Your R3 is set to automatically check for software
updates. If one is available, you will be asked whether
you want to download and install it.
CAUTION: Disconnecting the power during a software
update could permanently damage your R3.
Factory reset
MENU > System > Factory reset
Resets all settings and clears presets.
or .