Soundoff Signal mpover EMPS202KE Manual Del Usuario página 4

with Clear Duty® Technology
THREADED
STUD x2
MULTI-MOUNT
1.800.338.7337 / www.soundoffsignal.com
4
STUD MOUNT - THREADED LIGHT
HEAT SINK
LOCKNUT x 2
90°±15° ADJUSTABLE
BRACKET
INSTALLATION:
Multi-Mount Bracket
1. Pre-drill mount holes as required (bracket holes and spacing
are indicated on page 10 (4") or page 11 (3").
2. Place bracket onto desired vehicle's surface and secure with
screws (not provided).
3. Install Heat Sink onto "mPOWER Stud Mount, Threaded" light
as indicated. Wire passes through center hole.
4. Install "mPOWER Stud Mount, Thread" light onto bracket as
indicated. Wire passes though rear relief.
5. Install 2 lock nuts onto "mPOWER Stuf Mount, Thread" light
as indicated. Hand tighten until final adjustment.
6. Adjust angle of light to desired direction and tighten 2 lock
nuts until secure.
7. Make wire connections.
mpower Spot 0121