Soundoff Signal mpover EMPS202KE Manual Del Usuario página 6

with Clear Duty® Technology
GRILLE MOUNT BACK PLATE (
EMPS202KG-(x)
1.800.338.7337 / www.soundoffsignal.com
6
)
FOR USE WITH STUD MOUNT MPOWERS
INSTALLATION:
Grille Mount Back Plate (EMPS202KG-(x))
1. Find placement for mpower
®
2. Use the Stud Mount templates on Page 11, for a 4" mpower
light, or Page 12, for a 3" mpower
location of the new mpower. These holes will be for the mpower
studs and wires.
3. Feed the wires through the wire exit hole first. Then push the
ONLY
®
studs through.
4. Put the back plate on the outer side of the surface you drilled into.
Then put the nuts onto the studs and tighten down.
light location.
®
light. Drill 3 holes in the
®
mpower Spot 0121