Tabla de contenido
Publicidad
WARNING
Risk of electrical shock .
To reduce the possibility
of serious injury,
always take the proper
precautions and unplug
the fixture before moving
or cleaning .
ETL Rating: VYPR Series fixtures are rated suitable for wet locations . A "wet location" is defined as an interior or exterior location in which water or
other liquids may drip, splash or flow on or against the electrical components of a lighting fixture . VYPR Series fixtures and power supply are certified to
meet UL standards (ETL) from the Intertek safety consulting and certification company . Systems are cETL listed and are rated IP66 by IEC standard 60529 .
The light source of this luminaire is not replaceable; when the light source reached its end of life the whole luminaire shall be replaced .
Horticulture Lighting, not suitable for household room illumination .
1 PPF calculations compiled using integrating sphere measurements and typical spectroadiometric data for each LED to determine typical fixture performance . Actual photometric results may
vary within the LED manufacturer's bin tolerance .
2 Wattage values are typical expected values . Fluence maintains a tolerance of ±10% on flux and power specifications . Target light levels can vary from projected levels depending on ambient
temperature, room reflections values and dirt accumulation .
10
CAUTION
WARNING
To prevent eye damage,
Fixture and power
avoid looking directly at
supply are UL 1598
the unshielded LEDs .
Wet Location rated but
are not designed to be
submerged in water . In
the event that the module
or power supply enclosure
becomes submersed, first
disengage the circuit
breaker, then unplug
submersed components
before proceeding to
remove from water .
CAUTION
CAUTION
LED and heatsink
To reduce the risk of
surfaces may be hot .
overheating or fire,
Allow sufficient cooling
never place operating
time before handling .
fixtures face down on
a flush surface . Always
allow for adequate
ventilation of fixtures
and power supplies .
Publicidad
Tabla de contenido
