Mounting; Placement; Installing The Wallplate - Wallbox PULSAR PLUS Manual De Usuario

EN
INSTALLATION
NEMA plug-in installation
Ensure the NEMA receptacle is correctly installed before connecting your charger. See instructions on Page 9.
Follow our recommendations
for location and positioning
the charger in page 8.
"
≈ 8
≈ 20 cm
Make sure the outlet is powered off!
10

Placement

1.
Using a wall stud finder, find the wall stud
nearest to the NEMA outlet. Mark a vertical line
approximately 20" (50cm) in length in line with
the wall stud.
Alternately you may find a suitable location on
a solid wall.
2.
Ensure that the placement of the NEMA
outlet and your charger will allow for an adequate
connection of the 12" (30cm) NEMA cable.
3.
Carefully lift the charger from the box, plug
the NEMA cable into the outlet, and position the
charger centered on the vertical line. Position the
charger such that the NEMA cable has a gentle
curve and is not stretched. Mark a horizontal line
at the bottom of the charger.
4.
Unplug your charger and carefully place it
back in the packaging box while you continue.

Installing the wallplate

1.
Remove the tape from the wallplate to detach
it from the charger.
2.
Place the wallplate with the bottom edge
aligned with the horizontal line and the center
holes aligned with the vertical line. Mark the
location of the holes.
INSTALLATION
NEMA plug-in installation
3.
Drill two holes with an appropriate sized bit.
Place the wallplate in alignment with the holes.
If you are mounting your charger on a solid wall,
use the wall anchors provided with your charger.
x2
4.
Firmly mount the wallplate using the provided
wall screws. Do not over-tighten the screws.
x2
ø6 x 50mm

Mounting

1.
Carefully remove your charger from the
packaging box and hang your charger from the
top of the wallplate.
2.
Secure the charger to the wallplate using
the provided wallplate screws. Do not over-
tighten.
x2
ø3.5 x 9.5mm
Proceed to the instructions for installing the
holster and operating your charger, pages 16-17.
11
EN