Kohler CLW Serie Manual De Instrucciones página 2

2. SURFACE MOUNTING THE
CABINET ON A WALL.
A. Install Mounting Bar.
1. Drill two 3/16 holes in bottom mounting bar at indent location.
Use the supplied anchors or locate studs if possible.
2. Drill 3/16" hole in wall for mounting bar anchors at locations
shown in Fig. 3. (If you do not use the anchor, drill a 3/32"pilot
hole.) After the holes are drilled, fit the mountingbar onto the
wall, refer to Fig. 3 for measurements, and Fig. 5 or information
on anchor cinching.
B. Install Top Clips
(Left and right top clips come connected, hold both clips and snap
them apart).
1. Fit cabinet into position on mounting bar as shown in Fig. 4A.
2. Place clip in position as shown in Fig. 4B and mark with a
pencil. Remove clip and cabinet and drill the pilot or anchor
holes where marked
3. Fix both the clips into position with a screw, and slide the clip
into the up position. Sit the cabinet on the mounting bar, then
lower and tighten the screws into place, as shown in Fig 4C.
4. See Fig. 5 for proper turns required for anchor cinching.
5. See page 3 for Side Kit Mirror application.
Fig. 4A
Cabinet bottom sits
in lip on bottom
mounting bar
11" bottom mounting bar for CLC15/20
INSTALLER'S NOTE:
Installing the cabinet on a wall without the door attached can make
installing easier for one person. Do not mount the doors until the box is
in or on the wall.
SS486 CLW Cabinets
.
#8 x 2" Hex
head screw &
Wall anchor
(use 1/4" driver)
Fig. 3
3/4"
Bottom of Cabinet
Fig. 4B & 4C
4C
Fig. 5
Once Screw is bottomed out on
mount clip, turn screw an additional
5 to 7 turns to fully expand the anchor.
Side view at top of cabinet
2
CLW20 4 1/2" from edge
CLW15
2" from edge
Side of Cabinet
4B
Wall anchor
(if required)
Top mount clip
#8 x 2" Hex head screw
(Use 1/4" driver)