5. INSTALLING THE TOOTHBRUSH COVERS & DOOR BUMPERS – see Fig. 9
1. Push the toothbrush covers into place, one up, one
down, one up, one down.
2. These covers can be "wiggled " free to clean the
bristle area when required.
3. Each door can hold four brushes, 2 large bent handle
type brushes (Reach®, Oral B®, Precision®, etc) 2
straight handle or childrens brushes
4. Install the clear door bumpers in the round indent
area at the top and bottom of the door.
6. INSTALLING THE SHELVES – see Fig. 10
1. Push/twist the pins
into place
A. Push one side of
the shelf into the
left or right clips
B. Snap the shelf
down into the
opposite side. If
the shelf is too
tight, repeat the
process from the
other side.
2. Fill the remaining
holes with the plugs.
Parts supplied with your cabinet.
Be sure to check the cardoard supports in the carton, glass parts are packed in them.
number.)
4 Side Kits brackets
(SS250)
2 Glass Shelves
(SHLFCLC15 & SHLFCLC20)
CLSK26 Side
Mirrors
11" Mounting Bar for
CLW1526 & CLW2026 (RO331100W)
Checklist • Care & Maintenance
1. Cleaning
A. The cabinet door and interior are constructed of mirror and
aluminum. Use only a damp cloth to clean. Spray the cloth,
not the mirror when cleaning. Mirrors are damaged by the use
of ammonia or vinegar based cleaners. Rubbing alcohol can
be used for stubborn stains.
B. Use no abrasive cleansers on any part of the cabinet.
C. The white frame should be cleaned with a damp cloth only.
SS486 CLW Cabinets
A
B
(For cabinet body and door replacement, call customer service with model
1 BAGCLCHGE
Hinge Kit
4
Fig. 9
Toothbrush
Covers
Fig. 10
Part List
- BAGCLCS (silver) BAGCLCW (white)
#8" X 3/8" Screws (SS344)
Snap-in Pins (SS131)
Door Bumpers (SS340)
#8 X 2" Hex Head Slotted
Screws (SS343)
4 Side Kits Bracket
Foam tape (SS329)
Toothbrush covers for 10" door
(SS332)W, (SS262)S
Door
Bumpers
2
Top Clips (SS265)
Screw Caps
(SS348)S
(SS341)W
#8 X 1/2" Phillips
Head Screws (SS328)
Wall Anchors (SS590)
Hole plugs (SS239)W
(SS134)S
Rev. 1 02/03
cabfax#0486