Optional Surface Mounting - ETI SH-40-30-840-SV Guía De Uso Y Cuidado

Optional Surface Mounting

1
Mounting to a flat surface - wall or ceiling
□ Drill two holes in the wall or ceiling 33-3/4 in. apart.
□ Insert a drywall anchor (not included) and a mounting screw (not included) into each drilled mounting hole, but do not tighten fully.
□ Align the keyholes on the shop light (A) with the mounting screws in the mounting surface.
□ Once the screw heads are through the large ends of the keyholes, slide the fixture until the heads of the screws slide into the
narrow ends of the keyholes.
□ Tighten the mounting screws in order to firmly secure the shop light (A) to the mounting surface.
Pull Cord
nOTe: Drywall anchors are only to be used for mounting the fixture onto plaster or drywall surfaces.
2
Locking the fixture to the mounting surface
□ Insert an additional screw (not included) in the ceiling at the end of the light
fixture to prevent the shop light (A) from accidentally sliding off the screw
heads. If the original mounting screws are on the left side of the keyholes,
mount another screw into the ceiling to the left of the fixture. If the original
mounting screws are on the right side of the keyholes, mount another
screw into the ceiling to the right of the fixture.
A
6
Screw
Keyhole
Screw