Operation - Glacier bay 67552-1001 Guía De Uso Y Mantenimiento

Installation (continued)
5
Making the waterline
connections
NOTE: The hot side inlet tube is indicated by a label.
If the label is not present, the hot supply tube is the longer
of the two inlet tubes.
□
Use 1/2 in. I.P.S. faucet connections (2), or use
supply line coupling nuts (3) (not included) with
a 3/8 in. O.D. ball-nose riser (1).
NOTE: Before tightening the faucet connector to the water
supply, apply a second wrench to the supply tube tting.
This will prevent the supply tube from moving or twisting
when tightening the faucet connector. Do not overtighten.

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator to ush the water lines.
□
Turn on the water supply and allow both hot
and cold water to run for at least one minute
each. This ushes away any debris that could
cause damage to internal parts.
□
While the water is running, check for leaks.
□
Turn off the water and replace the aerator.
1
3
7
Please contact 1-855-HD-GLACIER for further assistance.
2
HOMEDEPOT.COM