Descargar Imprimir esta página

Marcato PASTADRIVE Instrucciones Para El Uso Y El Mantenimiento página 7

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
nearest authorized service facility for examination, repair or electrical or mechanical
adjustment.
8. The use of attachments not recommended or sold by the manufacturer may cause fire,
electric shock or injury.
9. Do not use outdoors.
10. Do not let cord hang over edge of table or counter.
11. This appliance is not intended for use by persons (including children) with reduced
physical, sensory, or mental capabilities, or lack of experience and knowledge, un-
less they are closely supervised and instructed concerning use of the appliance by
a person responsable for their safety. Close supervision is necessary when appliance
is used by or near children. Children should be supervised to ensure that they do
not play with this appliance. This appliance is not to be used by children. Keep the
appliance and its cable out of reach of children.
SAVE THESE INSTRUCTIONS
This appliance has a polarized plug (one blade is wide than other). To reduce the rick of
electrical shock, the plug will fit in a polarized outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electri-
cian. Do not modify the plug in any way.
Download this instruction at: www.marcato.it
HOW TO INSTALL THE "PASTADRIVE" MOTOR ON "MARCATO" PASTA MACHINES
For safety reasons, it is recommended to always secure the machine to the table using the
special clamp (Fig. 1), although it can also be used without clamping it down.
Before connecting the power supply, please make sure that the mains voltage is the same
as the one indicated on the rating plate of the motor (Fig. 2).
To install the motor on the smooth rollers, move it close to the machine tilted upward by
30°, then insert the pin in the hole drilled in the rollers (Fig. 3).
Push the motor until it leans against the side. Rotate the motor downward by 30° to
hook it into the holes drilled in the side panel. Start the motor by pressing the switch to
position I (continuous) (Fig. 4-5).
To remove the motor from the machine body, rotate it upward by about 30°, at the same
time pulling it outward (Fig. 6).
The crossed-out wheeled bin means that within the European Union the product
must be taken to separate collection at the product end-of life.
Do not dispose of these products as unsorted municipal waste.
7

Publicidad

loading