Gedore DREMASTER Z Instrucciones De Manejo página 13

Calculation of the torque setting for divergent depth gauges in
respect of the SE adaptor:
The new torque setting M
following formula:
l l l
k CSE zert
= The torque which must be set on the torque
M
xW
wrench scale.
= The torque with which the screw or nut
M
A
is to be tightened.
l = The distance between the face of the torque
WSE
wrench SE adaptor and the center of the handle
(see table in section 7).
= The distance between the face of the torque
l
CSE
wrench SE adaptor and the center of the screw
or nut (also referred to as tool accessory depth
gauge).
l = depth gauge specified in the certificate.
zert
= adaptor correction dimension.
l
k
EN
is calculated according to the
xW
15
M

A
M
 l
xW
l
k
 l
WSE
WSE